login to FusionPBX WebUI at and do initial setup & install load OpenWRT webpage at in a PC web browser, login and "Enable" php5-fastcgi and freeswitch daemons to run at startup on System-Startup-Initscripts page Luci and FusionPBX are installed in different OpenWRT dirs), ensure in /etc/php.ini parameter 'doc_root =' has empty value if using uhttpd with multiple package roots (i.e. using vi text editor, append to /etc/config/uhttpd an extra set of FusionPBX params from this Mazilo's post (or from Gerrit's Guide instead - they're the same, except FusionPBX installation dir) Opkg install zoneinfo-core zoneinfo-northamerica install more required extras (you may need to install more packages later depending on your PBX tasks scope): the step ln –s /usr/bin/php-cli /usr/bin/php is not needed proceed step-by-step with installing and configuring FusionPBX, PHP and FreeSwitch modules with above Gerrit's Guide opkg update - run before installing anything Finally Gerrit's Guide Installing FreeSwitch & FusionPBX on OpenWRT was used with some changes due to latest FusionPBX release (Rev 5666 at the moment) from SVN: I mostly followed Mazilo's Guide on Installing OpenWRT (Kirkwood build) on a USB Thumb hooked to Dockstar, while its original firmware on flash was left intact. Original bootloader was replaced with moded Doozan's Uboot installed on Dockstar's flash from a PC via SSH using Putty, and its env params modified via Netconsole to allow boot from a multi-volume Thumb without opening the device's case for JTAG or Serial hack. I just installed FreeSwitch to current stable OpenWRT release Attitude Adjustment 12.09 on Seagate Dockstar (Kirkwood CPU) laying around unused for sometime, and then installed FusionPBX to it - the advanced FreeSwitch WebUI Config Tool. INSTALLING FREESWITCH & FUSIONPBX ON DOCKSTAR
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |